Mercer Island homes from the 1960s and 1970s often feature original fiberglass or tile showers that fail when King County's mild wet winters drive constant moisture against aging seals. Water migrates behind the surround and into the subfloor, especially in properties close to Luther Burbank Park where humidity stays high. We remove the old unit, inspect for rot, and install a pre-sloped pan with modern waterproofing membrane rated for the region's freeze-thaw cycles.
Access on the island means working around I-90 Bridge traffic and narrow driveways common in West Mercer and Downtown Mercer Island neighborhoods. We stage materials on-site to avoid multiple trips across the bridge to Bellevue suppliers. Every replacement includes new valve bodies and shut-offs because older copper lines in these houses frequently corrode at the shower connection.
Code requirements in King County now call for a topical waterproofing layer extending 72 inches up the walls and a curbless option where the floor slope allows. We also address the dry-summer dust that can infiltrate during demolition if windows face the prevailing winds off Lake Washington.
Technician insight
In Mercer Island, the thing that catches most people out with Shower Replacement is how wet winters push water behind 1970s tile in homes near the I-90 corridor before owners notice. The island's older stock often lacks the modern membrane layer now required, so the job always starts with checking the subfloor under the pan rather than just swapping the surround.
North Mercer Island Shower Replacement
Homeowner near the Community Center reported slow drain and musty smell after several wet winters. We found saturated subfloor plywood under the original fiberglass unit. Removed the shower, replaced damaged joist sections, installed new pre-sloped pan with full membrane, and tied into existing drain line. Shower now drains cleanly with no odor return.
How it works
- 1
Site Assessment
Measure the existing shower, check subfloor condition, and note access constraints typical of Mercer Island lots.
- 2
Demolition and Prep
Remove old surround and pan, inspect for moisture damage, and install new blocking where needed for the replacement unit.
- 3
Waterproofing and Install
Apply membrane system, set new pan and walls, and connect valve with updated shut-offs suited to local water pressure.
- 4
Final Seal and Test
Grout or caulk all joints, run full water test, and confirm drainage before cleanup.
Pricing
Cost depends on size, existing damage, and whether a curbless conversion is requested; we provide upfront quotes after the on-site visit.